membuat charger usb sendiri

Today i am going to teach you how to make a USB charger for your cellphone to charge in your car or on your PC or Laptop...

Step 1: Materials Required and opening up the charger.

• 

  Image Notes

  1. opening up the charger
  2. removing the wire from the charger
• 

Materials Required: 1 x old usb Cable, 1 x old cellphone charger which is not working(because we just need the pin of from that), and 1 x Multi charger junction.

Pl. follow the following steps to make it work..

Step 1) First of all break open the old cellphone charger, and desolder the two wires from the circuit board which goes to the charger pin.

Step 2: Making the charger pin ready.

• 

  Image Notes

  1. detached wire from the charger
• 

  Image Notes

  1. This is the other end of the wire
  2. This is the other end of the wire

Step 2) Remove the plastic coating and make it ready to attach to the usb cable.

Step 3: Slashing up the USB cable.

• 

  Image Notes

  1. old usb cable
• 

  Image Notes

  1. cutting and snipping out the wires of the usb cable
  2. cutting and snipping out the wires of the usb cable
• 

  Image Notes

  1. snipped wires of the usb cable

Step 3) Now take the USB cable and cut it up to your appropriate length, and remove the plastic coating from the wires to attach it to the charger pin.(Here i have cut the extra two wire in the USB cable<green and white> because we just need the black and the red ones, which are the(+) and (-) ones the other two which i have strippen off are the Data (+) And Data (-), we just dont need them.)

Step 4: Connection!

• 

  Image Notes

  1. connecting the wires of the usb cable and the charger cable (NOTE THAT A USB CABLES CONTAIN 4 WIRES, VIZ. POWER & - AND DATA & -, WE ONLY NEED THE POWER & - ONES. I JUST HAVE STRIPPED OF THE DATA THAT IS THE GREEN AND WHITE ONES NORMALLY)

Step 4) Now connect both the charger pin wires and the USB cable wires to each other(RED to RED & BLACK to BLACK)

Step 5: Insulation!

• 

  Image Notes

  1. secure the connection with the help of an insulation tape or a heat shrink to avoid short circuit

Step 5) Now secure the connections with the help of insulating tape to prevent short circuit.

Step 6: Attaching the charger pin to the multi charger junction.

• 

  Image Notes

  1. attach these two...
• 

Step 6) Now attach the cellphone charger pin to the multi charger junction port, and connect the pin from it to your cellphone.

Step 7: Connecting the USB to any USB port u like(I have attached it to my PC)

• 

  Image Notes

  1. in my case i have connected my charger to my pc

Step 7) Now connect the USB cable to either your PC, Laptop, in your Car, or any where else where USB port is available, it conveniently charges our device.

Step 8: IT WORKED WITH MY CAR MUSIC SYSTEM TOO...!

• 

  Image Notes

  1. Yahoo! u are done...

Yepeeee! You are now done...